Post-Construction Cleaning Cost: What to Expect in 2026

Most published estimates put post-construction cleaning between about $0.15 and $0.80 per square foot. Homes sit at the low end and large commercial projects at the high end. For a typical 2,000-square-foot home, that works out to roughly $300 to $1,200, and the finishes, ceiling height and amount of dust decide where you land. Below, we break down how the price is built, what moves it and how to read a quote, from our side as a San Diego cleaning crew.
TL;DR
- Residential post-construction cleaning is commonly estimated at $0.15 to $0.60 per square foot, or about $350 to $1,200 per project. Commercial work is quoted higher per foot and in much larger totals.
- Price is driven by square footage, how many cleaning phases you need, ceiling height, floor type, debris and how fine the dust is.
- A good quote is a flat rate with a written scope, not a vague hourly guess.
- Schedule the final clean after the last trade leaves and before furniture or inspections, so the crew is not cleaning the same dust twice.
- We quote post-construction jobs across San Diego County. Request a quote with your square footage and project type.
Table of Contents
- What post-construction cleaning typically costs
- How the three phases affect the price
- What makes the cost go up or down
- What is in a quote
- What post-construction cleaning includes
- Post-construction cleaning versus regular janitorial service
- Our perspective
- How to schedule the clean
- Get a post-construction quote in San Diego County
- FAQ
- Sources
What post-construction cleaning typically costs
No single national price exists, because every remodel leaves a different mess. The published ranges below come from industry guides, and they vary by source, so treat them as a planning band rather than a promise.
| Source type | Per square foot | Typical project total |
|---|---|---|
| Residential guide, May 2026 | $0.15 to $0.60 (about $0.25 typical) | About $500 for a 2,000 sq ft home |
| Full three-phase scope | $0.30 to $0.70+ | $350 to $1,200 residential, $1,500 to $5,000+ large commercial |
| Commercial field guide, 2025 | $0.40 to $0.80 | $20,000 to $40,000 for a 50,000 sq ft project |
The gaps between these rows are real. A single-phase final clean of a small bathroom remodel and a full three-phase scope on a new build are different jobs, even though both are called post-construction cleaning.
A worked example for a home
Take a 2,000-square-foot home after a kitchen and bath remodel. One guide lists a minimum of 8 hours with 2 workers and labor at $30 to $50 per worker per hour. That is 16 labor hours, or about $480 to $800 in labor before supplies, equipment and debris hauling. It lines up with the $500 to $1,200 many homeowners see for a full interior clean.

Now take a gut remodel of the same house, with drywall sanding throughout. The dust is in every closet, vent and light fixture. More hours, more passes and more vacuum filters. Expect to land in the upper half of the range or beyond it.
A worked example for a commercial space
A 5,000-square-foot tenant improvement, such as a new dental office or retail shell, at the commercial field guide’s $0.40 to $0.80 per square foot comes to $2,000 to $4,000 for the full bundle. The same source notes that high-end finishes like marble or museum-quality glass can push costs 50 to 100% over those ranges, because they need slower, more careful handling.

How the three phases affect the price
Commercial and larger residential jobs are often split into three phases, and each one is priced on its own. Here is the per-square-foot breakdown one cost guide uses:
| Phase | When it happens | Per square foot |
|---|---|---|
| Rough clean | During construction, to keep the site safe and workable | $0.10 to $0.25 |
| Final clean | After the trades finish, before handover or move-in | $0.15 to $0.35 |
| Touch-up clean | After the punch list and final inspections | $0.05 to $0.15 |
Most homeowners only need the final clean, sometimes with a touch-up after the last punch-list fixes. A general contractor on a larger project may book all three. Ask which phases a quote covers before you compare totals, because a low number often just means fewer phases.
What makes the cost go up or down
Square footage is the starting point, but these factors move the final number more than most people expect.
Things that raise the price
- Ceiling height. One guide notes that ceilings over 12 feet need ladders, scaffolding or lifts, adding 20% to 35% to final clean labor time. Vaulted living rooms in many San Diego homes fall into this group.
- Floor type. The same guide says unsealed concrete or VCT tile in commercial spaces may need stripping, waxing or machine scrubbing, adding $0.20 to $0.50 per square foot.
- Fine dust. Drywall, tile cutting and sanding leave dust that settles in cabinets, window tracks, vents and the tops of door frames. It takes several passes to remove.
- Paint, stucco and adhesive residue. Overspray on glass and stickers on windows take careful scraping and the right tools.
- Debris. Leftover material that has to be hauled away adds disposal time and fees.
- Number of windows, fixtures and built-ins. Every pane, track and light fixture is hand work.
- Tight deadlines. A same-week handover before a walkthrough or listing photos can require a bigger crew.
Things that keep the price down
- A contractor who does a rough clean and hauls debris before the final clean starts.
- Clear access: power, water and parking for the crew.
- Protective film and floor covering left in place until the last trade is done, then removed as part of the clean.
- A flexible schedule, so the crew can work in a single stretch without waiting on other trades.
What is in a quote
Line-item breakdowns help you see where the money goes. One cost guide splits a typical final construction cleaning quote into labor at $25 to $70 per hour, disposal at $150 to $1,000, equipment at $50 to $400, supplies at $25 to $250, permits or fees at $0 to $300 and overhead at $0 to $750. It advises buyers to request a line-item quote with per-unit charges.
When you collect quotes, put them side by side and check these points:
- Square footage used. Is it your measured area or a guess?
- Phases covered. Rough, final, touch-up, or just one.
- Flat rate or hourly. A flat rate protects you if the job runs long.
- Scope in writing. Windows inside and out, cabinets inside, vents, light fixtures, appliances, garage.
- Debris handling. Is hauling included or extra?
- Crew and insurance. Who is entering the site, and are they background-checked?
- What happens if something is missed. Look for a reclean policy.
If you are renovating a house with the plan to sell it, it also helps to understand why repairs cost sellers more than the invoices alone suggest. A clean finish matters when a buyer walks through, so budget for the final clean along with the trades.
What post-construction cleaning includes
A full interior final clean usually covers the following. Our own post-construction cleaning checklist goes through it room by room.
- Dusting every surface from the ceiling down: fans, vents, light fixtures, window sills, baseboards, door frames and trim
- Vacuuming and mopping floors, with attention to corners and thresholds
- Cleaning inside and outside of cabinets and drawers, and removing dust from shelves and closets
- Scrubbing kitchens and bathrooms, including sinks, tubs, showers, tile and grout
- Wiping appliances, inside and out
- Cleaning interior windows, tracks and screens, and removing stickers, tape and paint specks
- Removing protective film and labels from fixtures and surfaces
- Final walkthrough to check for missed spots
Large commercial projects add items like restroom partitions, stripped and sealed floors, exterior glass and dock areas. They also follow a stricter handover schedule set by the general contractor.
Post-construction cleaning versus regular janitorial service
The two are priced differently because the work is different. Janitorial service is recurring upkeep: trash, restrooms, floors and high-touch surfaces on a set schedule. A post-construction clean is a one-time reset of a space that has never been occupied or has just been through heavy work. It deals with fine dust, adhesives and residue that routine cleaning does not touch, so it takes more labor hours per square foot.
A good plan for a new office or clinic is a post-construction clean before opening, then a recurring janitorial or office cleaning plan to keep it that way.
Our perspective
We started Mexi Maids because we saw how impersonal cleaning could feel in San Diego, and we still work the way a family business should: you know who is coming, and you know what you are paying.
Post-construction cleaning is where that matters most. The house is not just dirty, it is full of fine dust that gets into places you never thought about, and you are usually on a deadline for an inspection, a move-in or listing photos. We think the right answer is a trained, background-checked crew, a written scope and a flat-rate quote, so the number you hear is the number you pay.
We also stand behind the work with a reclean guarantee. If we miss something, we come back. That is how we want every customer, homeowner or contractor, to feel at the final walkthrough.
David
How to schedule the clean
Timing saves money. Here is the order we recommend.
- Finish punch-list work first. Cleaning before the last painter or electrician leaves means cleaning twice.
- Remove large debris. Your contractor should haul away drywall scraps, packaging and leftover material.
- Book the final clean. Aim for it after the trades finish and before furniture, rugs or inspection day.
- Schedule a touch-up if needed. Small fixes after the clean can leave new dust.
- Plan the move-in. Once the home is clean, a regular housekeeping plan keeps it that way.
If you are also moving into the home, ask us about move-in cleaning so cabinets, appliances and bathrooms are ready before the boxes arrive.
Get a post-construction quote in San Diego County
We clean after remodels and new builds for homeowners, contractors and builders across the county. Our crews are trained and background-checked, we use eco-friendly products, and we quote flat rates with a reclean guarantee behind the work. We are rated 4.8 stars across more than 190 Google reviews.

Tell us the square footage, the type of project and your handover date, and we will put together a quote through our commercial and post-construction services page. You can also see local pages for San Diego, La Jolla, Coronado, Carlsbad and El Cajon.
FAQ
How much does post-construction cleaning cost per square foot?
Published estimates range from about $0.15 to $0.60 per square foot for residential work, with a typical figure near $0.25. A full three-phase commercial bundle is estimated at $0.40 to $0.80. Your quote depends on the phases, finishes and amount of dust.
Is post-construction cleaning the same as a deep clean?
No. A deep clean resets a home that has been lived in, while post-construction cleaning removes fine dust, adhesive and residue left by building work. A deep clean may be enough for a minor touch-up job. Read our guide on deep cleaning versus regular cleaning for the difference.
When should I book the cleaning?
Book it for after the last trade finishes and before you move furniture in or schedule inspections. If your project is on a tight timeline, contact us early so we can reserve a crew for your handover date.
Why is a flat-rate quote better than an hourly one?
A flat rate fixes the price against a written scope, so you are not paying more if the job runs longer than expected. We quote flat rates for our cleaning services so you can plan the budget before work begins.
Sources
- Plyrium Academy: adding move-in/out, deep cleans and post-construction cleaning
- Post-Construction Cleaning Cost Guide: per sq. ft. rates
- Opora field guide: post-construction cleaning
- Final construction cleaning prices: typical cost and price ranges
- Why repairs cost sellers more
